netstat
ifconfig
chdev
no
多选题Which three options can be used with the load CLI command？（）AmergeBreplaceCpartialDcompleteEoverride
点击查看答案
单选题A Network Engineer is reporting that one of the AIX hosts is generating too much ICMP traffic, which is slowing the network. Which of the following options is the most probable cause?（）A A large FTP job is in process. B A network interface was misconfigured. C The ping command is being used excessively. D A bad network interface card and/or network cable is in use.
单选题Which statement about the ip classless router command is true?（）A The ip classless command is enabled by default in recent versions of IOS.B The ip classless command should only be enabled when static routing is being used instead of a routing protocol.C The ip classless command should be enabled by the network administrator whenever RIPv1 or IGRP is being used.D The ip classless command should be enabled by the network administrator whenever OSPF, RIPv2, or EIGRP is being used.
多选题The following configuration command was issued on router TK1:ip route 172.16.3.0 255.255.255.0 192.168.2.1.Which of the following statements are true regarding this command?（）AThe command is used to establish a static route.BThe default administrative distance is used.CThe command is used to configure the default route.DThe subnet mask for the source address is 255.255.255.0EThe command is used to establish a stub network
多选题A network administrator issues the ping 192.168.2.5 command and successfully tests connectivity to a host that has been newly connected to the network. Which protocols were used during the test? （）AARPBCDPCDHCPDDNSEICMP
多选题Which two data types can be converted to LOBs using an ALTER TABLE… MODIFY command？（）ARAWBLONGCVARCHARDLONG RAW
多选题Which two statements are true about Unicast Reverse Path Forwarding Loose Mode？（）AIt is used in multihome network scenarios.BIt can be used with BGP to mitigate DoS and DDoS.CIt does not need to have CEF enabled.DIt is enabled via the interface level command ip verify unicast reverse-path.EIt cannot be used with classification access lists.
